Automatic Nipple Feeder for Bicycle Rim
CM-A1, CM-A2, CM-A3, CM-A4
For Lacing Nipple size from G12 ~ G15 into bicycle or electric bicycle rim. The nipple will be send to the driver end fast and steadily. The operation just spend they time in aiming the hole for rim and collecting the spoke. Just one push stroke. Simplify the process even the new coming can reach the performance of skillful operator.
Nickname
Automatic Nipple Lacing for Bicycle Rim
Features
1. Without Manual Handling of the Nipple.
The nipple will be send to the driver end fast and steadily. The operation just spend they time in aiming the hole for rim and collecting the spoke. Just one push stroke. Simplify the process even the new coming can reach the performance of skillful operator.
2. Exchangeable Screwdriver Sets for Different Deep of Rim
There are three options of screwdriver sets to fit different application of variety type of rim.
The feeder is the same, but you just change the screwdriver for single wall of rim and different depth of double wall of rim. It only takes one minute to change the screwdriver set. Easy, Flexible, Economic!
3. For Motorcycle and Bicycle Industry
These machine have different models size for Nipple G8, G9, G10, G11, G12, G13, G14, G15.
Specification
Without the trouble of manual handling nipples, the nipple is send to the driver tip fast and steadily. Assembly work can be completely simply by a slight push.
The specific Screwdriver Set is suitable for the concave environment around drilling hole in the Motorcycle rim.
It achieves higher production efficiency at 40 rims per hour. Compact mechanical structure achieves easier maintenance while providing lower maintenance cost and shorter investment return.
Spring Balancer is equipped for operating the Pneumatic Screwdriver spritely and flexibly without burden.
The bit is provided with 3mm Pin to achieve appropriate driving depth for the Nipple so as to avoid unbalanced rim fastening.
It is provided with CM-T2 Wheel Assembly Table and is suitable for various kinds and sizes of rims. Further, the high-low position is also adjustable according to the respective application habitude. Besides, the Hub Holding Mode can also be replaced according to different hub pattern.
It is provided with CM-T3 Machine Table to achieve neat and aesthetic look of the production line. Further, the Suspension Arm is also provided for installing the Spring Balancer.